BMW S1000RR Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
So I changed the tyre and now QS is not working for 3rd and 4th gear. Took it to the dealership and scanner showed suspension and gearshift adjustment errors so removed that but still shows some volt and adjustment gear problem like it has too many electronical limits set.. Can I use an after market QS for it? Does that work regardless of any adjustments electronics.?
 

·
Registered
Joined
·
14 Posts
Discussion Starter · #3 ·
Hi thanks for the reply. Stuck with the problem been a week. So I will explain the whole situation .

It's Brentuned Stage 2. The Quickshifter was working fine until I changed tyres and mechanic did some chain adjustments as well..

Quickshifter locks/doesnt work on high rpm's in 3rd 4th and now on even low rpm's.. The dealership did some kind of reset but not sure if adaptations were reset is it the same as Quickshifter reset?

It was giving suspension and quickshifter lever error which was removed.. It is asking for software update as well but i didnt go for it will it remove brentune mapping?

Finally the latest diagnose was that 2.20 V was showing where as min limit was 2.50 V and up for gear settings... That's what the mechanic showed me and said it needs to be in limit over 2.5 V to work.. so might have to check gear adjustments and qs adjustment manually..

So he will work on it but if you can help me out here more I will be really grateful.. Thank you Sir.
 
1 - 7 of 7 Posts
Top