Install instructions...
Remove both side panels from bike. Remove the stock BMW badge (if not removed already) by pulling with your fingers or using a small flat screwdriver to pry them off. Take care not to scuff the edge with a screw driver. A hair dryer may help with the removal.
Drill a 3/8” hole in the CENTER of the round mounting area, centered between the 2 current holes. This is for wire routing.
Run the wires through the drilled hole and mount the signal with the supplied stainless steel socket head screws. The screws have a lock washer and only need to be hand tight. DO NOT OVER TORQUE!
Repeat steps for other side.
Connect the wires to the stock wiring. Red is Positive, Black is neg.
Reinstall side panels
You can order yours at
www.360Signals.net
