Austinracing ARCS GP3 Install Update

[Neo]

When you install the GP3 to ensure the bracket mounted onto your end can is not under any stress you may need to space it away from the frame mount slightly.
This depends on where you cut your cat off, the bracket was designed to work with the cat cut 50/50 material left on cat and headers. If you slightly vary from that it could pull your can bracket away from the frame mount hole causing stress to the bracket. Simply use spacer washers to take up any space between the frame and bracket prior to tightening the bolt and 2-1 cone clamp.

[shavkatsi12]

Neo, would you be able to post installation instructions/send them to me, please? Due to me debating on which exhaust should I get I need more info on ARCS GP3 installation, especially how much will I have to cut and where exactly... any contribution is very much appreciated. Unfortunately GP3 full system is a little bit out of my budget (as I would like to get a bellypan too)...
Thank you.

[Neo]

Can i have your email address i will then mail them to you.

[shavkatsi12]

cubenetworkz at gmail dot com

Sent from my HTC HD2 using Motorcycle App