1st Dyno Run

[JohnSmith]

Got the bike on the dyno today out of curiosity and because of all the crazy horsepower #'s I'm hearing and reading about.

The number I got was 181.21bhp. Unfortunately, I didn't get a torque number. I'll post the sheet when I get a scanner or a phone with a better camera.
My bike has a Comp Werkes slip-on, but is otherwise stock. I figure with a PC and some tuning time, I could probably see an extra 2-3 ponies...

Is this similar to what other people are getting with a basically stock set-up??

[wot]

SAE or STD ?

[rod]

My bike was dyno'd at the local tuner a couple of weeks back and made over 186.

Full Chart
Top speed run

Bike is completely stock BTW.

[Nigel]

Originally Posted by rod

My bike was dyno'd at the local tuner a couple of weeks back and made over 186.

Full Chart
Top speed run

Bike is completely stock BTW.

Cool. But you realize you cannot compare any dyno figures to anyone elses unless the bike was run on the same dyno as yours.

Just for interest, you have Conti tyres on yours right?

N.

[rod]

Originally Posted by Nigel

Cool. But you realize you cannot compare any dyno figures to anyone elses unless the bike was run on the same dyno as yours.

Just for interest, you have Conti tyres on yours right?

N.

Erm yes...

Nope tyres are Racetecs.. what made you think they were Conti ?

[JohnSmith]

Originally Posted by wot

SAE or STD ?

STD Not sure what the difference is though

[Nigel]

Originally Posted by rod

Erm yes...

Nope tyres are Racetecs.. what made you think they were Conti ?

Well it was either that or the dyno was off. The Racetecs should get you 192/193 at 14000rpm. 188 from the Contis though, they are quite a bit smaller (the 190/55's have a 2.01,5 running circumference vs the 2.03,5 of the Racetecs).

Nigel.