Just finished installing Passport SR7 with laser shifter

**yangins** · 12-17-2011, 11:40 AM

Everything went together well. Took a little thinking of were to put all three sensor?

Mack · 12-17-2011, 12:29 PM

Interesting.

Have any photos of the front and rear sensors/jammers and their placement?

Any thoughts on protection from rain/washing and the receiver under the dash as it appears "Not weather proof?"

Mack

**yangins** · 12-17-2011, 12:50 PM

Here some picture of sensor placements. All the external sensor are weather seal from the Factory. Were I have the display unit not much water gets there. Only holes on the display unit is the switch and speaker hole. If your are concern with water and ride in bad weathers just shink wrap the front of the display or relocate in the tail storge. Then get a helmet LED setup like the I purchase.

The Juntion box for all the sensor is in the Tail section.

Front Senor are the hards to place for a clean/stealth look. I hope ne of my police officer will help me out in test the laser shifter this spring.

Mack · 12-17-2011, 03:22 PM

I thought of that front position before, but on my other bike I had something there and the forked compressed and broke it (I think it was some small aftermarket running PIAA lights?).

Have you compressed the front fully to see if it won't hit it?

I thought about making some black plastic box above the license plate in the back and try to make it look like the original and leave the lens in it to somehow appear stock. Dunno.

Mack

shashankmittal · 12-17-2011, 04:14 PM

I like the creativity in the placement of all units. As Mack pointed out, I would be curious too to know your feedback about forks fully compressed.

**yangins** · 12-17-2011, 04:24 PM

Sensor is less than 1 inch tick. I will be compressing the forks to make sure it does not hit. If it does I have a few solution but it will require a lot more time.

The second picture of the rats nest in the tail section. The power bar setup and relayed directly powered/fused to the battery. It powers my Bazzaz and Phone charger setup also. The ignition tune the relay on and off.

Passport SR7 is made for a full size vehicle so there a lot of extra wires to hide. I have 4 months to make it look good back there.
Just an update the H.A.R.D helmet LED warning setup doesn't work on the Passport SR7 setup. It will work on any other Passport , Valentine 1 or Beltonics radar detector.

Guess Some will get a good deal on it in classified later.