S1000RR Do-It-Yourself [Archive] - BMW S1000RR Forums: BMW Sportbike Forum
PDA

: S1000RR Do-It-Yourself

  1. "Wireless" HID Conversion How-to (low/high beam)
  2. Hi-Beam Switch Repair
  3. Lower/Narrower Seat
  4. Placing bar end mirrors on stock clip-ons
  5. Home built Radiator protector project!
  6. Yoshimura fender eliminator kit install
  7. Apex Bars write up with pics
  8. Sato Racing Hooks + Powerlet install
  9. The $10 solution to protect your radiator and oil cooler
  10. DIY: PCV - Enabling the Gear Selection Option for Custom Fuel Maps for Each Gear
  11. Complete PAIR System Removal
  12. Flushing/Bleeding the Brakes
  13. Pipeworx Tail Tidy install and review
  14. Luimoto Seat Cover Install - Front and Back
  15. Air Filter Service / Replacement
  16. S1000RR HID conversion with 1offmotorsport kit
  17. Oberon Bar End Turn Signal Installation Video
  18. Installation of Oxford Heated grips, throttlemeister, power outlet, trickle charger
  19. Step-by-step for No-mar Tire Changer
  20. Where to install/put your PCV, AutoTuner, and Toggle Switch
  21. DIY front brake pads
  22. Installing a hardwired power outlet and GPS mount
  23. Installing Ohlins Forks, Removing Stock Forks, Frt Wheel, and Setting SAG, all in one
  24. What it takes to install an Akrapovic Exhaust, or Most Any Full System...
  25. Scottoiler Fitting
  26. SLIPPER CLUTCHES - How they work, & STM UPGRADE
  27. Shaving the seat down
  28. How to Plug/Block the PAIR Valve
  29. Step by Step/Battery Charger/Powerlet Socket Install
  30. Rear brake lever too low?
  31. Gilles Frame Slider Installation
  32. S1000RR Do-It-Yourself Rules
  33. Scorpio Alarm - Project Done
  34. Custom Tidy Tail
  35. Drop Sensor - Installation
  36. Slick Mode Plug - Installation
  37. Exhaust Valve Mod - Little More Rumble at Idle!!
Terms of Use